48
Student control
PPM output setting
Set the type of PPM signal output from the trainer port,
such as
signal polarity
,
Number of channels
,
Period and
Starting level
.
Binding with FS-WTM01
Bind the transmitter with the wireless trainer module.
Perform the switching to indicate whether the student accepts
the control or not. Normally, this switch state is effective when
Trainer control
of trainer mode is disabled.
Function setup:
Click
Student control
to enter the switch assignment menu
and set the appropriate button. Refer to Chapter 16 in this
manual.
Note: Under normal circumstances, make sure that the student control
switch is enabled. In this case, the student signal can be sent to the
trainer transmitter. Usually, the switch can be set to "--" and normally ON.
Please refer to chapter 16 for the switch setting. When the trainer uses
the student mode to remotely assist the student to practice, the control
authority can only be switched through this switch if the control authority
needs to be switched. For details of application scenarios, see the later
section.
Refer to
RF setting
section for the description of function
setup.
Function setup:
1. Tap
Binding with WTM01
to enter the binding screen,
then put the transmitter into binding mode.
2. Power on the wireless trainer unit and put it into binding
mode. The LED of the wireless trainer unit is solid on
after the binding is successful.
Notes:
1. After the model is switched, the wireless trainer unit shall be
rebound. The receiver bound in the previous model shall be
reboundnext time.
2. In the binding, make sure that the working mode of wireless trainer
module is matched. For details, see the manual.
7.13.2 Trainer mode
When the trainer mode is set as trainer, it means that the
transmitter only supports the functions of trainer mode.
At this time, you can set the matched student mode of
transmitter through the trainer control switch and input
channel to realize the application of trainer transmitter
function.
Trainer mode
Switching between trainer mode and student mode. By
default, it is student mode in the system.
Function setup:
Click
Trainer Mode
to switch between
Tainer
and
Student
.
