50
Description of trainer coaching.
1. This transmitter can be set to student mode. At this
time, when a switch can be assigned to control whether
the student control signal is sent to the trainer mode
of transmitter, and the trainer mode of transmitter can
automatically switch to trainer control according to the
abnormality (loss) of the student remote control signal.
2. According to the above principles, when the trainer
coaching is needed in the training, students can set
their transmitters as trainer mode and assign the
corresponding channels of trainer control signals. The
trainer control switch is kept normally
OFF
. The trainer
sets his own transmitter as student mode and assigns a
student control switch.
3. During use, the trainer sets the student control switch
to OFF by toggle switch. At this time, the student can
concentrate on practicing with his own aircraft, and the
trainer can observe aside and switch to take over the
control when he confirms that the student needs help.
Note: This mode is applicable to only PL18 transmitter with firmware
version 1.0.65 or above.
