56
8.6 Program Mixs
A new special control combo can be created to correct the disadvantages of the model. You can select a stick/knob
or a function as a
Master
. When selecting a function, you can set whether other mixes associated with the function
affect the
Slave
of the same group and whether the trim affects the
Slave
. The function can be used to set the servo
change of the
Master
mapping to the
Slave
channel through a custom curve. You can set a switch to enable/disable
the
Mix
, and set the delay to enable/disable the
Mix
function. Please note if the master is set to a slow action by
Set
by function
in
the
Servo speed
function, the
Slave
will also follow the
Master
to perform the slow action.
It can be used for a variety of applications:
link
with other mixes, separate link settings for the master and slave with
reversal direction of the connection; trim mode enabled or disabled; and curve mixing rate and mixing delay can be
set separately for each group of
Mix
.
⑴
⑶
⑷
⑵
⑸ ⑹
Switches which turn on/off the
Mixes
.
The interface shows below when the
Master
is set to a control.
The interface shows below when the
Master
is set to a function.
Tap to enter the corresponding switch setting interface of each
Mix
.
Tap to enter the corresponding mix setting interface of each
Mix
.
⑴
Tap to enter the interface of
Mix delay
.
⑵
Click to enter the corresponding interface of
Master
or
Slave
.
⑶
Tap to enter the interface of
Mix rate
.
⑷
Tap to set the link mode of
Slave
to
Master
.
⑹
Tap to set to turn on/off the trim of
Master
.
⑸
Tap to set the link mode of
Master
to
Slave
.
Note: When the
Mix
activates and the trim of its
Master
is set to
On
, the trim of its Mater will affect its
Slave
. If the trim is
set to
Off
, the trim of
Master
will not affect the
Slave
.
⑴
⑵
8.6.1 Setting Master and Slave
Sets related settings of
Master
and
Slave
.
⑴
Tap to enter the screen of setting
Master
's
control.
⑵
Click to enter the screen of setting
Master
's
function.
