62
8.11 Throttle needle
The throttle needle function is set for some models with a throttle needle. This function is used to set the output
rate of the throttle needle master control in a multi-point curve method.
For example, if you need to link a throttle to a needle, you can assign the throttle needle controlled by the throttle
stick, and realize the control of the throttle stick to the needle by setting the curve.
The setting steps of throttle needle are similar to the setting steps of throttle curve. Refer to the related setings of
throttle curve.
Note: This function is available for version 1.0.65 or above.
Note: This function is available for version 1.0.65 or above.
8.12 Aileron
Aileron
（
Airfoil
）
Flap
（
Airfoil
）
Flap2
(Brake) Flap3
(Brake) Flap4
Aileron 3
Aileron 4
Rudder 2
Rudder
Aileron 2
Tap to select
Offset
.
Tap to enter switch assigned interface.
set the appropriate value. Click to return
to the previous interface.
Note: For settings of switch, refer to the descriptions in
chapter 16.
Note: If the offset value is negative, it means
the idle speed is rising. When the offset value is
maximum, it indicates that the throttle stick is
close to the minimum throttle.
This section introduces the settings of the aileron and its mixes function. The parameter settings of this function are
for the current condition. To set in another condition, you need to switch the condition first.
Note: Due to the different model structures (for example, different number of ailerons and flaps), the corresponding function interface
may be different. Usually, up to four ailerons are described as an example.
