64
8.12.4 Aileron brake flap
This mixes function is used to set the linkage between
the brake flap and the aileron so that the flap can work
together with the aileron, thus improving the maneuvering
characteristics around the longitudinal axis.
Note: This function is only available with 4 flaps.
Take the setting of
Low
as an example.
Function setup:
1.
Tap the item corresponding to
Low
you want to set, The
currently selected function item is highlighted in light
green.
2. Click
+
or
-
to set the appropriate value. Then click to
return to the previous interface.
8.12.5 Aileron to elevator
Usually more lift is needed on ailerons when turning/
rolling. This function allows you to set the compensation
rate of the elevator during aileron movement, so that the
elevator will be subject to a compensatory trim according
to the set rate during aileron movement, thus preventing
the nose-down of the aircraft.
Note: If the model structure is a tailless (flying wing) aircraft, the
aileron can be used as an elevator. This setting will affect all elevator
surfaces, and even the aileron surfaces in case of a tailless aircraft.
Take the setting of
Low
as an example.
Function setup:
1.
Tap the item corresponding to
Low
you want to set,
The currently selected function item is highlighted in
light green.
2. Click
+
or
-
to set the appropriate value.
3.
Set a switch to enable this function. Tap the box next
to
Start switch
to enter switch assigning interface.
Then click to return to the previous interface.
8.12.6 Aileron to rudder
This mixes function is used to set the linkage between the
steering servo and the aileron. This function can be set to
achieve the more coordinated and flexible steering and roll
through the compensatory trim of the steering servo during
the aileron movement.
Note: When there are two rudders, rudder 1 and 2 will both be affected.
Take the setting of
Low
as an example.
Function setup:
1.
Tap the item corresponding to
Low
you want to set,
The
For the setting of
High
, refer to the setting of
Low
.
For the setting of
High
, refer to the setting of
Low
.
Tap to select the
rate
.
⑴
⑴
⑵
⑵
⑴
Tap to enter the switch assigning interface.
⑴
Tap to enter the switch assigning interface.
⑵
Tap to select the
rate
.
⑵
Tap to select the
rate
.
Note: For settings of switch, refer to the descriptions in chapter 16.
