73
Note: This function is available for version 1.0.65 or above.
8.18 Butterfly
8.19 V tail
This function realizes deceleration by adjusting the rates of ailerons, flaps, spoilers and elevator, i.e., ailerons
are raised and flaps are lowered at the same time. This function is very effective when the model is landing, i.e.,
reducing the speed of the model, more stall margin is provided at the wingtip, thus less risk of wingtip stall. And
more lift is generated at the root of the wing, allowing less gliding speed.
This function is used to adjust the rate of the V-shaped tail’s 2 tail fins in steering and pitching manes. The V-shaped
tail aircraft performs the rudder and elevator movements via 2 servos. In this system, one of the tail implements the
rudder function and the other performs the elevator function, corresponding to two channels respectively. When the
rudder function is implemented, the two control surfaces move in opposite directions. When the elevator function
is implemented, the two control surfaces move in the same direction. This interface allows you to set the elevator
rate and rudder rate, i.e., the rate of the elevator is for realizing the elevator function and the rate of the rudder is for
realizing the rudder function.
Notes:
This function is available for multi-flap airplane.
Take the setting of
AILE
as an example.
Function setup:
1.
Tap the function box corresponding to
AILE
you
want to set, the currently selected function item
is highlighted in light green.
2. Click
+
or
-
to set the appropriate value. Then
click to return to the previous interface.
Function setup:
1.
Tap
V Tail
to enter the setting interface.
2. Tap
Elevator rate
, then click
+
or
-
to set the
appropriate value.
3. Tap
Rudder rate
, then click
+
or
-
to set the
appropriate value. Click to return to the previous
interface.
For the setting of other function, refer to the
description above.
⑴
⑴
⑵
⑴
Tap to select the
rate
.
⑵
Tap to enter the switch assigning interface.
Note: For settings of switch, refer to the descriptions in chapter 16.
Note:
This function is available for models with V Tail.
Note: The number of ailerons displayed is
based on the settings of wing layout.
