77
9.13 Throttle needle
Please refer to
8.11 Throttle needle
for this function.
9.14 Swashplate
9.15 Thro mixed
9.16 Swashplate ring
In the current condition, correspond the helicopter's ailerons, elevation and pitch to the mixes of the servos to
achieve the best flight effect.
In the current condition, set the helicopter's ailerons, elevation and rudder to the throttle's mixes rate. It is used to
coordinate the flight movements of the helicopter in all directions (forward, backward, left and right) to compensate
for the effect of swashplate manipulation on the engine when operating ailerons, elevation and direction.
Limit the angle of swashplate movement. Change the helicopter's cycle pitch by adjusting the travel range of
ailerons and elevation channels to control the helicopter's movements in all directions (forward, backward, left and
right). If the ailerons and elevation travel range change too much, and the helicopter's swashplate angle exceeds the
limit of the mechanical structure, the helicopter might be seriously damaged. Therefore, this function can protect
the helicopter's mechanical structure.
This is a swashplate related advanced function. If you protect the mechanical structure by limiting the aileron and
elevation movements via maximum travel range, the swashplate movements will be greatly restrained. But this
function allows users to obtain more operation room while ensuring performance of the function.
Note: This function is derived from the original mixes and is only available on 1.0.65 and later versions..
Note: This function is derived from the original mixes and is only available on 1.0.65 and later versions..
Tap to select the
rate
.
Tap to select the
rate
.
Function setup:
1.
Tap
Swashplate mix
to enter the setting
interface.
2. Tap item you want to set.
3. Click
+
or
-
to set the appropriate value. Click
to return to the previous interface.
Function setup:
1.
Tap
Thro mixed
to enter the setting interface.
2. Tap item you want to set.
3. Click
+
or
-
to set the appropriate value. Click
to return to the previous interface.
