61
8.9 Throttle cut
This function is a special setting for oil-operated engine. The
Cut switch
,
Cut position
and
Cut Threshold
can be
set. When the throttle control stick is within the throttle cut threshold, toggle the throttle cut switch to turn off the
engine. The output value of the throttle function when the throttle cut is in effect is the throttle cut position value. It
will be limited by the channel reverse function and the channel range function, and all other volumes operated to the
channel corresponding to this throttle are invalid. However, the other functions of throttle mixing are still worked.
Multi-engine model can be set with the throttle cut separately for throttle, throttle 2, throttle 3 and throttle 4.
8.10 Idle up
This function can be used to set the throttle idle position, which can prevent the engine from shutting down when
the throttle stick is in a lower position. The minimum throttle position is defined by setting the offset value. Once
this function is activated, the minimum throttle setting (idle point) will be determined by the offset value, expressed
as a percentage. For safety reasons, this function will work only when the throttle stick is below the lower position
(-20%). The idle speed offset values of -100-0-100 correspond to a ratio factor of 80%-100-120%. The throttle control
ratio will be multiplied with the ratio factor corresponding to the offset when the idle speed is enabled for the
subsequent operation (throttle curve). When the throttle cut is enabled, the throttle hold and this function are not
valid.
In multi-engine model, the idle switch is recognized only in the "throttle" control position (below -20%), and the
throttle, throttle 2, throttle 3 and throttle 4 will be calculated when the idle is enabled.
Note: This function is available for version 1.0.65 or above.
Note: This function is available for version 1.0.65 or above.
Function setup:
1. Tap the function box next to
Cut switch
to enter.
2. Set a switch to turn on or off the
Throttle cut
. Then
tap to return to the previous interface.
3. Tap the function box next to
Cut position,
then click
+
or
-
to set the appropriate value. Click to return
to the previous interface.
4. Toggle the switch to confirm whether it is work
properly.
Function setup:
1. Tap the function box next to
Idle switch
to enter.
2. Set a switch to turn on or off the
Idle up
. Then click to
return to the previous interface.
3. Tap the function box next to
Offset
, then click
+
or
-
to
Notes:
1. When multiple throttles are set, choose
Model > Type > Optional
,
and click
Throttle
, to select the appropriate number of throttles.
After setting, this interface will show multiple throttles. Click the
corresponding throttle to set them separately. Refer to the above
for settings.
2. For settings of switch, refer to the descriptions in chapter 16.
Tap to select
Cut Threshold
.
Tap to select the throttle.
Tap to select
Cut position
.
The yellow bar presents the
Cut position
.
Tap to enter the interface of switch assigned.
The interface for multiple throttle
