65
Note: This function is available for version 1.0.65 or above.
8.13 Flap
Aileron
（
Airfoil
）
Flap
（
Airfoil
）
Flap2
(Brake) Flap3
(Brake) Flap4
Aileron 3
Aileron 4
Rudder 2
Rudder
Aileron 2
This section introduces the settings of the flap and its mixes function. The parameter settings of this function are for
the current condition. To set in another condition, you need to switch the condition first.
Note: Due to the different model structures (for example, different number of ailerons and flaps), the corresponding function interface
may be different. Usually, up to four ailerons are described as an example.
currently selected function item is highlighted in light
green.
2. Click
+
or
-
to set the appropriate value.
3.
Set a switch to enable this function. Tap the box next
to
Start switch
to enter switch assigning interface.
Then click to return to the previous interface.
For the setting of
High
, refer to the setting of
Low
.
Note: For settings of switch, refer to the descriptions in chapter 16.
8.13.1 Flap setting
This function is used to set the high and low end rates and
offset of flaps separately, that is, for a model with multiple flaps,
the flap upward and downward movement travel and neutral
point position on each flap can be adjusted independently.
Note: The number of interface flap function items is related to the Wing
through Models.
Take the setting of
Low
as an example.
Function setup:
1.
Tap the item corresponding to
Low
you want to set, The
currently selected function item is highlighted in light green.
2. Click
+
or
-
to set the appropriate value. Then click to
return to the previous interface.
Offset indicates the input which centers on
the neutral position will move lower or higher
according to the offset value.
⑴
⑴
⑴
Tap to select the rate.
Note: Offset in the interface of the Flap and
Airbrake has similar meanings.
For the setting of
High
and
Offset
, refer to the setting of
Low
.
