66
8.13.2 Brake to Airfoil
This mixes function is used to set the high to low rate
of brake flaps to airfoil flaps. It is used to adjust the
up/down movement travel range of multiple flaps
independently.
Note: This function is only available with 4 flaps.
Take the setting of
Low
as an example.
Function setup:
1.
Tap the item corresponding to
Low
you want to set,
The currently selected function item is highlighted in
light green.
2. Click
+
or
-
to set the appropriate value.
3.
Set a switch to enable this function. Tap the box next
to
Start switch
to enter switch assigning interface.
Then click to return to the previous interface.
8.13.3 Airfoil to Elevator
This mixes function is used to set the linkage between
the wing flap and elevator. You can set a compensatory
trim for the elevator to prevent the aircraft from diving
when the airfoil flap is operated to slow down.
Note: For normal tail/V tail/double elevator tails, the function item
is only Elevator/Elevator 2. For those having aileron but without
tail ( There is no elevator function item, the number of aileron
function items depends on the actual number of ailerons), set
the aileron as the elevator, so as to achieve the Airfoil to Elevator
function.
Take the setting of
Low
as an example.
Function setup:
1.
Tap the item corresponding to
Low
you want to set,
The currently selected function item is highlighted in
light green.
2. Click
+
or
-
to set the appropriate value. Then click
to return to the previous interface.
For the setting of
High
, refer to the setting of
Low
.
For the setting of
High
, refer to the setting of
Low
.
Note: For settings of switch, refer to the descriptions in chapter 16.
⑴
⑵
⑴
Tap to enter the switch assigning interface.
⑵
Tap to select the
rate
.
The interface is for the model has elevators.
The interface is for the model has no elevators.
Tap to select the
rate
.
Tap to select the
rate
.
