68
Note: This function is available for version 1.0.65 or above.
8.15 Spoiler
Spoiler, also called deceleration flap, can achieve fast braking by increasing the aircraft pressure on the ground when
the aircraft is descending. Meanwhile, the use of spoiler in flight can also achieve the effect of aircraft deceleration.
This function can be used to set the upward and downward movements of each spoiler and the linkage between
spoiler and elevator. If the spoiler is used during deceleration, the aircraft will tend to dive. If the elevator linkage
is set, the flight attitude can be controlled through the compensatory trim of the elevator. The function parameter
setting is for the current condition. To set in another condition, you need to switch the condition first.
8.14.1 Brake speed
Sets the parameters related to the brake speed
function. You can set the time to complete the
action when the brake is enabled and disabled. The
longer the time, the slower the speed.
Take the setting of
Offset 1
brake
as an example.
Function setup:
1.
Tap
Offset 1 brake
, the currently selected
function item is highlighted in light green.
2. Click
+
or
-
to set the appropriate value. Then
click to return to the previous interface.
8.14.2 Brake rate
Sets the offsets of
AILE
,
Flap
,
Spoiler
and
Elevator
for the current condition. To set in another mode,
you need to switch the condition first.
Take the setting of
Offset 1
brake of
AILE
as an
example.
Function setup:
1.
Tap the function box corresponding to
AILE
, the
currently selected function item is highlighted in
light green.
2. Click
+
or
-
to set the appropriate value. Then
click to return to the previous interface.
For the setting of
Offset 2 brake
and
Stop braking
,
refer to the setting of
Offset 1 brake
.
For the setting of offset value of other function,
refer to the description above.
⑴
⑵
⑶
⑶
Tap to select
Stop braking
.
Tap to select
Offset
for the corresponding
function.
⑴
Tap to select
Offset 1 brake
.
⑵
Tap to select
Offset 2 brake
.
Notes:
1. Due to the different model structures (for example, different number of ailerons), the corresponding function menu may be different.
Usually, up to four ailerons are described as an example.
2. If it is a flying wing type aircraft, the elevation setting item is aileron; or, use the flap function to add setting interfaces for the aircraft.
