69
Take the setting of
Low
as an example.
Function setup:
1.
Tap the item corresponding to
Low
you want
to set, The currently selected function item is
highlighted in light green.
2. Click
+
or
-
to set the appropriate value. Then click
to return to the previous interface.
Spoilers
For the setting of
High
, refer to the setting of
Low
.
Tap to select the
rate
.
Note: This function is available for version 1.0.65 or above.
8.16 Elevator
This section introduces the settings of the elevator and its mixes function. The parameter settings of this function
are for the current condition. To set in another condition, you need to switch the condition first.
Notes:
1. Due to the different model structures (for example, different number of ailerons and flaps), the corresponding function menu may be
different.
2. The aileron movement mode is not restricted in the mixing linkage of the elevator and aileron.
8.16.1 Elev. Linkage
This mixes function is used to adjust the rise and
fall rates of left and right elevators separately.
Take the setting of Low as an example.
Function setup:
1.
Tap the function box corresponding to
Low
you
want to set, the currently selected function item
is highlighted in light green.
2. Click
+
or
-
to set the appropriate value. Then
click to return to the previous interface.
For the setting of
High
, refer to the description
above.
