76
9.8 Throttle curve
9.10 Throttle cut
9.11 Idle up
9.9 Pitch curve
9.12 Throttle hold
Please refer to
8.8 Throttle curve
for this function.
Please refer to
8.9 Throttle cut
for this function.
Please refer to
8.10 Idle up
for this function.
In the current condition, adjust the motion curve of the helicopter's pitch to match the throttle output to achieve
the best flight status. To set in another condition, you need to switch the condition first. Different output rate can be
obtained through multi-point linear settings (up to 11 points).
Quickly locking the throttle channel output value at a preset value by one switch can assist in spin landing, or act
as a throttle lock switch to lock the throttle position in a safe place during commissioning. This function is not valid
when the throttle cut switch is on. When the throttle hold is on, the mixes of the throttle from other functions is
invalid. The throttle function is output after channel operations (Travel, Range, Normal and Reverse and channel
delay) with the set hold values. The throttle function's mixes on other functions is also brought into operation using
the value.
Function setup:
For the setting of
Rate
/
Offset
, refer to the
description in
Throttle curve
above. For the Line
type, please refer to the descriptions in chapter
16.
⑴
⑵
⑴
Displays the value of the throttle hold when the
throttle hold function enables.
⑵
"
Throttle is normal!
" indicates the throttle
hold function is disabled and the throttle status
is normal. If the throttle hold function is enabled,
the prompt changes to "
Throttle held!
" in red.
Function setup:
1.
Tap
Throttle hold
to enter the setting interface.
2. Click
+
or
-
to set the appropriate value.
3.
Click to set the switch to enable/disable the
function
.
Note: For settings of switch, refer to the descriptions in chapter 16.
