79
9.18 Gyroscope
9.19 Governor
Set the output value of gyroscope channel.
The system is preset with two gyroscope modes to switch between by a switch. You can switch between the modes
to adjust the gyroscope channel output sensitivity. It is recommended to assign a two-position switch to switch
between gyroscope 1 and gyroscope 2.
The function parameter setting is for the current condition. To set in another condition, you need to switch the
condition first.
Set the output value of
Governor
channel to adjust the RPM of the helicopter propeller to make the helicopter fly
more stable. The function parameter setting is for the current condition. To set in another condition, you need to
switch the condition first.
Function setup:
1.
Tap
Gyroscope
to enter.
2.
Tap to enter, then assign a switch to control this
function. For example, assign
SWB
in up position to
turn on
Gyroscope1
.
3.
Move the
SWB
switch to the up position and use
+
or
–
to change the sensitivity value of
Gyroscope1
.
4.
Move the
SWB
switch to the down position and use
+
or
–
to change the sensitivity value of
Gyroscope2
.
Click to return to the previous interface.
Note: For settings of switch, refer to the descriptions in chapter 16.
Function setup:
1.
Tap
Governor
to enter the setting interface.
2. Click
+
or
-
to set the appropriate value. Click
to return to the previous interface.
9.20 Logic switches
Please refer to
8.20 Logic switches
for this function.
