81
10.8 Throttle curve
10.9 Throttle hold
10.10 Attitude
Please refer to
8.8 Throttle curve
for this function.
Please refer to
9.12 Throttle hold
for this function.
This function allows the setting up to 9 output values for channels assigned with attitude functions. The output
value of the channel can be switched via the set combo switch.
Function setup:
1.
Tap
Attitude
to enter the setting interface.
2. Tap the function box with "
--
" to enter the switch
assignment interface. Tap a switch you want to set or
push/ pull the physial switch on the transmitter. Click
to return to the previous interface. After these two
switches are assigned, the function and its output
value are contolled by the comno switch.
3.
Change the names of the presets by taping the dark
green function box you want to change. A pop-up
menu comes along with it, you can tap the appropriate
charater then click
Enter
to complete.
4. Click
+
or
-
to set the appropriate value. Use the combo
switch to swith the function. Click to return to the
previous interface.
Notes:
1. The rate value indicates the output in percentage of a channel.
2. The combo switch needs to be set before other rate functions can
be selected. You can switch 9 output values via this combo switch
after the setting is completed.
3. Only toggle switch can be assigned.
⑴ ⑵
⑴ / ⑵
Tap to enter the switch assignment
interface. "
--
" indicates that the switch is
unassigned.
⑶
⑶
Tap the dark/light green area, you can set the
output names of the nine channels.
The switch assignment interface
The interface of the switch assigned
Tap to cancel the assigned switch.
