5.When the FlyTech Dragonfly is fully charged, its eyes will stop pulsing,
and turn off.
Note that the eyes
will blink rapidly if there is no signal from the controller. When charging the
dragonfly, make sure the cord from the controller is properly connected to the
socket on the dragonfly.
6. Carefully unplug the charging cord from the dragonfly,
then replace the cord back in the compartment of the
controller and then close the compartment door. Now you
are ready to fly!
NOTE:
When the dragonfly’s is running low,
you will notice his eyes will begin to dim and
the sound of the motor on the dragonfly
begin to splutter or become less responsive.
Flying
When the dragonfly is fully charged and ready to fly, you can take your FlyTech
Dragonfly to the skies!
Location
You can operate FlyTech Dragonfly both indoors
and outdoors. The maximum recommended range
for the controller is 45 meters (150 feet).
Flight modes
You can operate FlyTech Dragonfly in one of two modes: Beginner or Expert. To
familiarize yourself with the controls, start with Beginner mode. Beginner mode
allows for more gentle turns, and Expert mode allows for sharper and faster turns. .
Once you are comfortable with the controls , you can switch to Expert mode.
To charge the dragonfly:
1. On the controller, push down on the magnetic perch. The cord compartment
door will open.
2. Pull the end of the cord from the compartment as shown.
3. Hold the dragonfly firmly by its body, and then insert the cord into the socket as
shown. Pay close attention to the orien tation of the socket and the connector
on the cord.
NOTE:
Make sure that the dragonfly is turned off before you recharge it.
IMPORTANT: Do not force the cord into the
socket – this can damage the socket. The
exposed silver contact points on the side of
the controller plug should line up with the
cut-away side of the socket.
NOTE:
The controller is equipped with a sleep feature, that is, the LED indicator
will turn off if the controller is idle for more than 1 minute. Therefore, when
charging FlyTech Dragonfly, the LED indicator light might turn off, however, the
controller will continue to charge the dragonfly. To turn the LED indicator light
back on, press the power button on the controller until the LED indicator lights
up again.
4 . Press the power button on the controller to turn it on.
If the connector on the cord is properly connected to the socket, the eyes on the
dragonfly will pulse slowly to indicate that it is charging.
NOTE:
You can rest the
dragonfly on the controller
while it is charging by placing
the metal perch point (on the
dragonfly) on the magnetic
perch (on the controller).
Expert mode
Beginner mode
