www.fmiproducts.com
125598-01D
7
INSTALLATION
Continued
INSTALLING DAMPER CLAMP ACCESSORY FOR
VENTED OPERATION
Note: When used as a vented indoor appliance, appliance
must be installed only in a solid-fuel burning fireplace with
a working flue and constructed of noncombustible material.
For Massachusetts Residents Only:
Installation of this gas
log set as a vented indoor appliance in the Commonwealth of
Massachusetts requires the damper be permanently removed
or welded in the fully open position.
You must install the damper clamp accessory (to order, see
Accessories
, page 23). This will insure vented operation (see
Figure 8). The damper clamp will keep damper open. Instal
-
lation instructions are included with clamp accessory.
See chart below for minimum permanent flue opening you
must provide. Attach damper clamp so the minimum perma
-
nent flue opening will be maintained at all times.
Area of Various Standard Round Flues
Diameter
Area
5"
20 sq. inches
6"
29 sq. inches
7"
39 sq. inches
8"
51 sq. inches
Chimney Height Minimum Permanent Flue Opening
6' to 15'
39 sq. inches
15' to 30' 29 sq. inches
Figure 8 - Attaching Damper Clamp
Damper
Damper
Clamp
Damper
Damper
Clamp
Damper
Manufactured Fireplace
Masonry Fireplace
INSTALLING APPLIANCE BASE ASSEMBLY
WARNING: You must secure this appliance
to fireplace floor. If not, appliance will move
when you adjust controls. Moving appliance
may cause a gas leak.
WARNING: If installing in a sunken fireplace,
special care is needed. You must raise the fire
-
place floor to allow access to appliance control
panel. This will insure adequate air flow and
guard against sooting and controls being dam
-
aged. Raise fireplace floor with noncombustible
material. Make sure material is secure.
Installation Items Needed
• hardware package (provided with appliance)
• approved flexible gas hose and fittings provided (if allowed
by local codes)
• sealant (resistant to propane/LP gas, not provided)
• electric drill with 3/16” masonry drill bit
Note: Install optional MRC Series receiver and hand-held
remote control kit (see
Accessories
, page 23) before install
-
ing gas log appliance. See installation instructions included
with the kit.
1. Apply pipe joint sealant lightly to male threads of the 1/2
NPT side of gas fitting elbow (provided) and connect to inlet
side of gas control. Remove gas fitting from flexible gas
hose (provided) before connecting to elbow (see Figure
9).
2. Position appliance base assembly in fireplace.
3. Mark screw locations through holes in front panel of base
(see Figure 10, page 8). If installing in a brick-bottom fire
-
place, mark screw locations in mortar joint of bricks.
4. Remove appliance base from fireplace.
5. Drill holes at marked locations using 3/16" drill bit.
6. Attach base, through holes in back side panels of base, to
fireplace floor using masonry screws provided in hardware
package (see Figure 10, page 8).
7. Connect to gas supply. See
Connecting To Gas Supply
.
Figure 9 - Attaching Flexible Gas Hose to Appliance
Gas Regulator
Gas Control
Flexible Gas Hose
(Provided with VGC
Series Models Only)
(Install if allowed by
local codes)
Elbow, 1/2 NPT x
3/8 Flare
