www.fmiproducts.com
125883-01C
13
OPERATION
Continued
TO TURN OFF GAS
TO APPLIANCE
1. Turn control knob clockwise
to the PILOT
position.
2. Press in and turn control clockwise
to the
OFF position.
3. Close equipment shutoff valve (see Figure 4,
page 7).
CURING
During 2-3 hour appliance break-in period,
you may detect an odor from the appliance as
various paints and compounds used in manu-
facturing of this fire ring. This is a normal and
temporary situation that is not cause for alarm.
To ensure proper curing:
• Ignite a 2" flame and maintain it for 1 hour.
• Burn in consecutive 1 hour periods raising
flame an additional 2" to full flame height for
a total of three hours.
INSPECTING BURNERS
Figure 20 - Pilot Assembly
Figure 21 - Location of the Pilot Adjustment Screw
Thermocouple
Pilot
Check pilot flame pattern and burner flame patterns
often.
PILOT ASSEMBLY
The pilot assembly is factory preset for proper flame
height. Alterations may have occurred during ship-
ping and handling. The pilot is located underneath
the pilot shield on the burner pan.
The thermocouple should be fully enveloped in
flame. The flame should not be lifting off of ther
-
mocouple element.
If your pilot assembly does not meet these require
-
ments:
• Access pilot adjustment screw through slot in
valve cover. Turn adjustment screw clockwise
to decrease or counterclockwise to increase the
flame to proper size (see Figure 21). Do not re
-
move adjustment screw.
• See
Troubleshooting
, page 15
Pilot
Adjustment
Screw
BURNER FLAME PATTERN
Burner flames will be steady, not lifting or floating.
Flames should go up through middle of the fire ring
burner in a tee pee formation.
Electronic
Ignitor
