D.210.000.V1
En-3
OUTLAND LIVING - PRINCETON 2-BURNER STOVE OWNER & SAFETY MANUAL
SUMMERLAND
Owner & Safety Manual
PRINCETON
2 BURNER GAS STOVE
SETUP: STANDING OPERATION
STEP 1: TAKE OUT WINDBREAK AND LEG EXTENSIONS
a) Release the 2x lid locks of the right lid
|and deploy the right lid then
the left lid.
IMPORTANT:
Ensure all 4x leg extensions are fully seated. The thumb screw
washer should be on top of the U slot. The thumb screws
should be fully tightened before turning the stove over.
Lid Lock
(2x)
Grill
Locking
Pin
Grill Locking Pin
U Slot
Leg Locking Thumb Screw
Stowed Windbreak
Leg
Extension
(4x)
SECTION 1:
ASSEMBLY (continued)
d) Close the grill and set the 2x grill locking pins. Ensure both 2x
pin ball bearings are fully through the holes and the ball bearing
engagement should be visible on the other side.
e) Close both lids and latch the 2x lid locks.
STEP 2: INSTALL LEG EXTENSIONS
a) Lay the appliance on its back. NOTE: To avoid scratching or
denting choose a flat non-marking surface.
b) Insert the legs into the ends of the leg extensions. The side with
the leg locking thumb screw should engage with the U slot of the
leg extension.
c) Ensure the legs are fully seated before tightening the leg locking
thumb screws.
d) Turn stove over and stand on legs.
b) Release the 2x grill locking pins.
c) Lift the grill to take out the windbreak and leg extensions.
