D.210.000.V1
En-5
OUTLAND LIVING - PRINCETON 2-BURNER STOVE OWNER & SAFETY MANUAL
SUMMERLAND
Owner & Safety Manual
PRINCETON
2 BURNER GAS STOVE
SECTION 2:
IGNITION
STEP 1
Ensure that each appliance valve dial is
in the “OFF” position by pushing and
turning clockwise until the dial stops.
STEP 2
Connect the LP gas cylinder. See section labeled “Connection”.
STEP 3
Extend hose to full length and ensure that the propane tank is as
far as safely possible from the appliance and place the tank in the
included stabilizer ring.
STEP 5
Leak Test all connections. See section labeled “Leak Test”.
STEP 4
***SLOWLY*** turn cylinder valve to the open position to avoid
tripping the excess flow safety device in the gas regulator. For more
information about the excess flow safety device see SECTION 5
(page 7).
SETUP: TABLE TOP DEPLOYMENT
1. Place appliance on a level, stable, non-combustible surface.
2. Release the 2x lid locks of the right lid and deploy the right lid
then the left lid.
3. Release the 2x grill locking pins and lift the grill to take out the
windbreak and leg extensions.
SECTION 1:
ASSEMBLY (continued)
NOTE TO USER:
Before igniting the unit for the first time, follow steps one through 5 in the below Ignition section.
IMPORTANT:
• Ensure the gas hose is not contacting the appliance enclosure
and the LP cylinder is stabilized.
• Perform LEAK TEST PRIOR TO IGNITION. Leak test all gas
coupling connections. (see section labelled “Leak Test”).
• Use caution, the hose is a potential trip hazard.
Ensure the gas hose is not contacting the appliance enclosure and
the LP cylinder is stabilized.
Caution: Always ensure the gas valve orifice and burner tube
venturi is clear of all debris including spider webs.
4. Store the legs safely away from appliance.
5. Close the grill and set the 2x grill locking pins. Ensure both 2x
pin ball bearings are fully through the holes and the ball bearing
engagement should be visible on the other side.
6. Deploy wind break.
7. Ensure the gas knobs on the appliance are set to OFF.
8. Connect LP cylinder (see section labelled “Connection”).
9. Your OUTLAND appliance is assembled and ready for use.
