En-6
1-888-514-1663 |
WWW.OUTLANDLIVING.COM
Upon igniting the appliance, visually
verify that the burner is indeed burning as
demonstrated in the image to the left.
The presence of flames will confirm that the
burner is burning.
Periodically check that the burner flame
is present during operation by visually
inspecting the burner to ensure the presence of flames.
SECTION 3:
PERIODIC INSPECTION OF BURNER FLAMES
If there are no flames present, as
demonstrated in the image to the left, the
appliance is likely not burning.
If this is the case, IMMEDIATELY turn the
valve to the “off” position if it is not already
and repeat the ignition procedure as outlined
in Section 2.
STEP 7
Once the unit is burning normally set
the dial to desired flame height.
TO ADJUST FLAME COLOUR MOVE
THE AIR-FUEL ADJUSTMENT LEVER
FOUND UNDER THE STOVE GAS
VALVE. ADJUST THE LEVER TO
MAXIMIZE THE BLUE FLAME. A
FLAME WITH MORE BLUE COLOUR IS
BURNING HOTTER, MORE CLEANLY
AND MORE EFFICIENTLY THAN A
YELLOW FLAME.
STEP 6
Using a lighter or match, ignite lighter and hold flame slightly above the burner, then open the valve on the appliance slowly by turning
(counter-clockwise) until the unit ignites.
Should the appliance fail to ignite on the first try, promptly repeat the ignition attempt within 5 seconds. If a third attempt fails to ignite the
appliance then rotate the knob to the “off” position and wait 5 minutes before attempting to ignite again.
SECTION 2:
IGNITION (continued)
Air-Fuel
Adjustment
Lever (2X)
SECTION 4:
EXTINGUISHING THE APPLIANCE
STEP 1
1. Turn valve on propane cylinder to “CLOSE” position.
2. Wait for flame to visibly extinguish.
3. Turn valve on unit to “OFF” position.
STEP 2
Allow unit to cool for at least five (5) minutes before relighting.
