Operating Manual EMGZ470A/472A
7
5
Quick Installation Guide
•
Check all your requirements such as: Configuration of the PROFIBUS interface
(address number, data format, required PROFIBUS cycle time, termination) and
calibration mode (ref. to „9. Calibrating the measuring amplifier“) etc..
•
Draw your final wiring diagram according to the FMS recomendations (refer to
„7.5 Wiring diagram)
•
Install and wire all your components (refer to „7. Installation and wiring“)
•
Make settings in the PROFIBUS master computer (DP master) (ref. to
„8. PROFIBUS Interface Description“)
•
Put measuring amplifier into operation and calibrate it by PROFIBUS (refer to
„9. Calibrating the measuring amplifier“)
•
Turn system on; proceed with a test run with low speed
•
If required, activate additional application-specific functions of the PROFIBUS
master computer (DP master)
Note
If a real-time control loop is implemented with the PROFIBUS, you must ensure
that the application-specific PROFIBUS protocol is timewise short enough to
provide sufficient control dynamics.