6
1.Slide vertical stabilizer in the rear of the fuselage.
2.Secure the vertical stabilizer using included screws as shown.
1.Make sure the servos are in the neutral position. Install the
linkage rod to elevator control horn as shown. Secure the linkage
rod in place using the included screw as shown.
2.Make sure the servos are in the neutral position. Install the l
inkage rod to rudder control horn as shown.
Note: Please refer to the control horn and servo arm settings in
page 11.
EN
Model assembly
Linkage rod installation
Vertical stabilizer installation
KA2.0*12
KA2.0*8
