5
Remove the partially attached circular pieces of foam on the main frame
piece you see above. You can simply pull them loose or use your knife to cut
them out.
6
Create a setup as seen above. Use a motor mount, motor mount installing
tool and 2 carbon rods. For this part of the build, make sure that both the
foam frame piece and the motor mount installing tool are on the same FLAT
surface. The carbon rods should be inserted deep enough, preferably until
they “touch” the motor mount installing tool. If the cuts that have been
machined in the foam frame piece don't go deep enough, use your hobby
knife to cut them deeper, but avoid cutting them completely through.
Summary of Contents for Baby Turtle
Page 13: ...Done weight without battery...
