Focal Point 18" High-Tech, Installation, Servecing And User Instructions

COMPONENT C

CHECKLIST

QUANTITY

DESCRIPTION

1

Firebox and burner tray assembly

1

Three piece decorative trim

1

Cast firefront

1

Moulded ceramic fibre combustion matrix

1

Left-hand Moulded ceramic front strip

1

Right-hand Moulded ceramic front strip

16

Individual ceramic coals

4

Ceramic ribbed effect radiant panels

3

Ceramic brick panel retaining clips

1

Cable fixing kit; 2 cables, 2 tensioners, 2 cable clamps, 4 eyebolts

1

Sealing grommet

3

Lengths of adhesive sealing strip

1

Self tapping screw pack; 4 No8 x 5/16

1

Set of manufacturers instructions

4

Fibre Rawl Plugs

PREPARING TTHE A

APPLIANCE

Note: EEnsure tthat tthe ggas ssupply iis iisolated bbefore ccommencing iinstallation oof tthe aappliance. 

The fireplace opening and environment must be in compliance with specifica-

tions laid down in the appropriate sections of these instructions.

Remove the appliance from it’s carton as described previously and stand upon
a dust sheet or similar. Place the decorative frame, coals, ceramics and fixings
safely to one side. Remove the burner from the assembly by removing the
retaining screws.  The tray is now free, and may be lifted away.

RADIANT PPANELS:  The three radiant panels may now be fixed inside the fire-
box. Select the patterned side of each panel and insert as follows; Lay the fire-
box on it’s back. Lay the tapered panel onto the rear face of the firebox. 

The side panels should be fitted by inserting their front edges into the pre-fitted
retaining brackets on the front face of the firebox. Gently align the side panels
with the side of the firebox as shown, over the top of the back panel already in
place. 

Make sure that the side panels are pushed up firmly to the roof of the firebox,
and back firmly to retain the tapered panel. Secure both side panels and the lower rear panel using the
small ‘L’ shaped brackets and screws provided (shown inset). The screws should locate into the pre-
punched holes in the sides of the firebox.

SPIGOT RRESTRICTOR: If installing the fire into a good Class 1  flue, simply bend up (stitch bend join)
the spigot restrictor into position in the flue outlet of the fire. You M

MUST rremove ((or bbend ddown

fully) tthe sspigot rrestrictor aand rre-ttest iif tthe aappliance ffails aa sspillage ttest dduring ccommissioning. 

SUPPLY PPIPE EENTRY:  Knockout holes are provided in the rear and sides of the
firebox for use where concealed pipework is required. Where necessary, knock
out the appropriate hole with a sharp tap from a hammer, and fit the rubber
grommet supplied. A small incision can now be made in the rubber to slip snug-
ly around the outside of the pipe and sleeving. 

Do nnot iinstall oor uuse tthe aappliance w

without tthe sseals iin pplace. If a hole is inad-

vertently opened, reseal with an intact grommet. Failure to fit the seal correct-
ly will cause flue suction to act upon the area under the burner, resulting in
poor performance and intermittent cutting out of the burner.

5

7.1

8.0