CONTENTS
PRELIMINARY NOTES
The Evoke Electric Wall Heater provides convected heating in conjunction with a LCD screen which can display a number
of different fuel effects and scenes. The appliance is designed for indoor use, and can be simply wall mounted in the major-
ity of wall positions anticipated. It can can be located in any household room, with the exception of bathrooms. Read all of
the instructions before commencing installation. Retain for future reference and pass on as necessary to subsequent owners
of the appliance.
DO NOT use this appliance immediately below a fixed socket outlet.
DO NOT use this appliance in the immediate vicinity of a bath, shower, swimming pool or other area where water/moisture
could present a hazard.
CAUTION: This appliance must not be used in conjunction with any timer, programmer or thermal control, or any other
device that will switch on the appliance automatically, as a fire risk may occur if the heaters are accidentally covered or dis-
placed.
Do not allow the heater to be covered as this may cause overheating. The appliance must not be placed near curtains or sim-
ilar material. A clearance space of at least 500mm should be allowed in front of the appliance.
The electrical socket that the appliance uses MUST be easily accessible. Do not route the supply cord directly over or above
the heater unit. If the cord is damaged, it must be replaced by a service agent or competent person.
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities,
or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appli-
ance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appli-
ance.
APPLIANCE DATA
ELECTRICAL INSTALLATION REQUIREMENTS
The appliance is designed to be wall mounted using the wall mounting plate and fixings provided.
DO NOT RECESS ANY PART OF THE APPLIANCE.
The appliance is supplied with a pre-wired three pin BS1363 plug (13 Amp fuse rated), and 2 metre cable. A standard
switched outlet/wall socket, (including earth provision), must therefore be located within this distance, and be easily acces-
sible in order to isolate the supply for maintenance and cleaning. This socket
must not be mounted behind or above the
appliance.
IMPORTANT: THIS APPLIANCE MUST BE EARTHED.
1
Section Contents
Page No.
1.0
Preliminary Notes
1
2.0
Appliance Data/Specifications
1
3.0
Electrical Installation Requirements
1
4.0
Site Requirements
2
5.0
Clearances to Combustible Materials
2
6.0
Unpacking the Appliance
2
7.0
Component Checklist
2
1.0
Section Contents
Page No.
8.0
Fixing the Appliance
3
9.0
Operating the Appliance
4
10.0
Safety Cut-Out System
5
11.0
Maintenance
6
12.0
Cleaning
6
13.0
Servicing
6
Weight (kg):
10.0 kg
Dimensions (mm):
H 480 x W 800 x D 154
Voltage (Volts):
230-240V a.c. 50Hz
Heating Elements:
2 x 900/1000 Watts
Supply Cord:
2 metres
Supply Plug:
BS 1363, 13A Fused
Location:
Indoor Use
LCD Display:
60 Watts
2.0
3.0
©
2008 Focal Point Fires plc.
