13
Mounting the loudspeaker
300 ICW products of the 300 SERIES include a mounting frame, a 300 ICW loudspeaker and both circular and square
magnetic grilles. No tools are required to mount the 300 ICW loudspeakers of the 300 SERIES range.
1.
Pivot the mounting bracket until it clips onto the mounting frame so that the mounting frame can be pushed
through the opening
(fig. 1
).
2.
With one hand, insert the mounting frame into the opening in the ceiling/wall, making sure it rests flush against
the ceiling/wall (
fig. 2
).
3.
To fasten the mounting frame to the ceiling/wall, insert your other hand into the opening, and use two fingers to
pivot the mounting bracket to the opposite side to its initial position (
fig. 3
)
4.
Push the mounting bracket down until it reaches the stop (
fig. 4
).
5.
Finally, release the mounting bracket making sure it is securely in place. Also make sure the mounting bracket
isn’t resting on the loudspeaker cable (
fig. 5
).
Note 1: repeat the operation for the other mounting brackets.
Note 2: to unlock the mounting bracket: use two fingers to pivot the mounting bracket towards the outside, pull
upwards and release.
6.
Connect the previously stripped loudspeaker wires to the spring loaded terminals on the loudspeaker. It is
essential to connect the loudspeakers respecting the correct polarity: the cable connected to the
"
+
"
terminal on
the amplifier must be connected to the red terminal on the loudspeaker. Likewise, the cable connected to the
"
-
"
terminal on the amplifier must be connected to the black terminal on the loudspeaker. Stereo image and bass
perception would be seriously compromised if these conditions were not respected (
fig. 6
).
7.
The loudspeakers are now ready to be assembled to the mounting frame. In order to do this, position the red
arrows on the loudspeaker in line with the open padlocks on the mounting frame (
fig. 8
).
Note: if you plan to use your product as in-ceiling loudspeakers, the loudspeaker can be securely fastened to the
ceiling using a safety sling (not supplied) which fastens to the hook on the rear of the product (
fig. 6
).
8.
Insert the loudspeaker into the mounting frame (
fig. 7
) until the stop, then pivot the loudspeaker using the red
handles so that the markers are positioned between two open padlocks (
fig. 9
).
9.
The circular or square grilles can now be mounted to the loudspeaker. The grille is held to the mounting frame
magnetically, all you need to do is simply line them up (
fig. 10
).
300 SERIES
U s e r m a n u a l
