8
> SUBWOOFER REMOTE VOLUME CONTROL LED LIGHT.
1.
While playing music the LED light should be Green.
Occasional red LED light flash indicates that the amplifier has reached maximum loudness.
2.
If the red LED light flashes with the beat of the music,
TURN DOWN THE VOLUME before you damage your speaker.
3.
If the red LED light is on continuous,
TURN DOWN THE VOLUME before you damage your speaker.
WARRANTY INFORMATION:
Focal America / Orca Design & Manufacturing supports their products and guarantees them to be free of
manufacturing defects for a period of
1 year (non-transferrable) from the date of purchase, if purchased
from and authorized retailer
. This time period is extended to
3 years (non-transferrable) from the date of
purchase, if the amplifier is purchased from and installed by an authorized retailer
, and
no alterations are
made to the installation or setup of the amplifier outside of the authorized retailer.
This manufacturing
warranty does not extend to situations involving physical or installation damage, misuse,
abuse, or modification. If an amplifier malfunctions, please return it to the authorized retailer from which the
amplifier was purchased to have the amplifier and/or installation inspected and to have the warranty period
verified from date of purchase.
The authorized dealer will then work with Focal America / Orca Design & Manufacturing to obtain service, if
necessary. If found to be a defect due to manufacturing, the item will be repaired or replaced with a refurbished
amplifier. The amplifier will be returned to the authorized retailer when repairs are complete, so that the
dealer can return the amplifier to you, or reinstall the amplifier to maintain the above mentioned warranty
timeline.
TECHNICAL SPECIFICATIONS:
Four X 150 watts at less than 1% THD into 4 ohms
Four X 200 watts at less than 1% THD into 2 ohms
Bridged, Two X 400 watts at less than 1% THD into 4 ohms
Frequency Response 5 Hz to 25 kHz.
S/N ratio 90 dB
RCA input can use a BTL source or common ground source.
RCA switch select balanced floating ground or grounded to
minimize noise.
Input sensitivity 200mV to 10 volts
Slew Rate 13 V / uS
Each input has a peak limiter to prevent clipping and
speaker damage.
Each channel has variable high pass crossover:
50 Hz to 4000 Hz, 12 dB Linkwitz-Riley
Each channel has variable low pass crossover:
50 Hz to 4000 Hz, 12 dB Linkwitz-Riley
Each channel has variable band pass crossover:
50 Hz to 4000 Hz, 12 dB Linkwitz-Riley
Channels 3, 4 in bridged subwoofer mode , 24 dB Linkwitz-Riley
Subwoofer remote volume control includes a clipping indicator light.
Recommended DC voltage operating range 11.5 to 14.4 volts.
Minimum DC voltage operating range 8 to 16 volts.
Length 7.71 inches Width 10 inches Height 1.97 inches
Weight 6 pounds
