FTS20182 - Battery Operated Spike Puller
FTS20182 Operation Manual
04-21-21
973.705.7133
customerservice@focusedts.com
6
MAINTENANCE
Daily: Check all accessible screws for tightness. Apply two pumps of provided lubricant every three to four
hours via maintenance port as in item 7 in operating procedures.
Note: Any major repair(s) must be performed by an authorized and certified dealer. Call 973-705-7187.
TROUBLESHOOTING
If symptoms of poor performance develop, the following points can be used as a guide to correct the problem.
When diagnosing faults in operation of the spike puller, always check the battery power source and battery
charge level.
Problem:
Solution:
Spike puller does not cycle properly
Check the power source for proper contact and make
sure the tool is properly lubricated.
Spike puller does not pull effectively
Check power source for damage and check trigger
switch to ensure proper setting for pulling.
Spike puller operates slowly
Check for low battery level and replace the battery. If
a Milwaukee drill is used, make sure it is set to #3.
Jaw does not retract or extend while operating
Check power source for proper contact, low battery,
or remove the battery and look into the chute for an
impedance. Remove impedance and replace the
battery.
*NEVER ACCESS UNIT WITH BATTERY ENGAGED
●
Always store the tool in a clean, dry space, safe from damage or pilferage. Also, ensure the battery is
disengaged and not on the tool.
●
Do not exceed the rated limits or use of the tool for applications beyond its designed capacity. (see
manual)
●
Always keep critical tool markings, such as labels and warning stickers legible.
●
Permit only authorized and certified dealers to perform tool repair.
