Folding Guard Qwik-Fence, Installation Instructions Manual

FGI-011_Rev.D  08/10/2015                                                                                                          Qwik-Fence Installation Instructions                                                                                                                                        

Toll Free: (800) 622-2214 
Phone: (708) 325-0400 
Fax: (708) 325-0450 

5858 W. 73

RD

 ST 

BEDFORD PARK, IL.  60638 

Qwik-Fence

®

12 

Hinge Door Assembly  

Fig.

8C

‐

1

Step 8C: Hinge (D2) Attachment 



Attach the Hinge (D2) to the end of the door opposite the lock, with the provided TEK  

Self Tapping Screws (F1).  Make sure the bend portion of the swing faces the way you intend your door to swing.   

For Hinge reference use Figure (8B-1).  For Attachment see Figure (8C-1). 

Line up the bottom and top of the hinge to the bottom and top of the door provided. 

Step 8D: Installing Stop Angle (D3) “Swing Out” option. 



If your Door Swings IN Lock Left or Lock Right reference (

Step 8E

): Installing Door. 



If your Door Swings OUT Lock Left or Lock Right, attach the Stop Angle (D3) to the end of the door.   

Attach with provided TEK Self Tapping Screws (F1). 

Make sure that the Rectangular Slot fits over the Lock Opening 
This can be done by lining up the back edge of Hinge (D2) to the Back edge of the door.   

As Shown in Figure (8D-1). 
Make sure that the top and bottom of the Stop Angle (D3) are approximately lined up with  
the top and bottom of the door. 

Fig.

8E

‐

1

Step 8E: Installing Door. 



Attach the Door to the Hinge post (Based on the direction and lock location of your door determined in (

Step 8B

),  

Figure (8B-1)).  Fasten with the provided TEK Self Tapping Screws (F7) into the pre-drilled holes; adjust for best swing. 



After installing the door, attach the Receiver Bar (D1) on the opposite post. (Make sure that the rectangular slot on the  

Receiver Bar (D1) lines up with the rectangular slot and the lock on the Door. Refer to Figure (8E-1)) 

Fig.

8D

‐

1

Fig.

8F

‐

1

Stop

Angle

Exis ng

Door

Receiver

Bar

Lock

Post

Step 8F: Installing “Swing In” option. 



If your Door Swings IN Lock Left or Right Attach the Angle to the Post Opposite the Hinge Post  

        AFTER you have Installed the Door as shown in Figure 8F-1 
 

Attach only at the top and the bottom, DO NOT screw in all the way. 



Place

the

Receiver

Bar

(D1)

on

top

of

Stop

Angle

(D3),

line

up

the

rectangular

opening

with

the

lock

on

the

door

and

a ach

using

provided

TEK

Self

Tapping

Screws

(F1)

into

the

pre

‐

drilled

holes.

Use

Figures

(8F

‐

1)

and

(8E

‐

1)

for

reference.

(A er

ensuring

that

all

assembly

parts

fi

t

ghten

the

screws).