FGI-011_Rev.D 08/10/2015 Qwik-Fence Installation Instructions
Toll Free: (800) 622-2214
Phone: (708) 325-0400
Fax: (708) 325-0450
5858 W. 73
RD
ST
BEDFORD PARK, IL. 60638
Qwik-Fence
®
7
Wall Kit Assembly
Fig.
2
‐
1
Step 1: Setting up for installation.
Plan the layout of the Qwik-Fence® Perimeter
Mark Every Post Location
Mark Every Door Location
To begin installation at a wall or corner. (Fig. 2-1)
See Wall Kit Instructions
Step 2
.
To start from a Post (M2)
Please skip to
Step 3
.
Fig.
2
‐
2
Step 2: Wall Kit Assembly
Attach the provided Wall Kit Angle (W1) to the existing wall with provided
Slotted Head Screw (F5) and Plastic Anchor (F6). See Figure 2-2 for refer-
ence.
Attach the Wire Mesh Panel
When attaching the Wire Mesh Panel (M1) DO NOT FORGET to
measure 2” from the floor to the bottom of the mesh to en-
sure fit with the Posts (M2).
Use the
5
/
16
” Masonry bit to pre-drill the hole for the wall anchor.
Insert the Carriage Bolt (F2) through the front of the angle and
in the back use the provided Mesh Clamp (B10) to clamp
the mesh to the angle, connect all with the Washer (F4) and
Nut (F3). Refer to Figures 2-3 and 2-4 for reference.
Refer back to
Step 1
for further reference.
Figure 2-4 shows final assembly including a post (M2) and Wire
Mesh (M2).
Fig.
2
‐
3
Fig.
2
‐
4
x6
x6