FGI-011_Rev.D 08/10/2015 Qwik-Fence Installation Instructions
Toll Free: (800) 622-2214
Phone: (708) 325-0400
Fax: (708) 325-0450
5858 W. 73
RD
ST
BEDFORD PARK, IL. 60638
Qwik-Fence
®
8
Post & Panel Assembly
Step 3: Adding a Post.
Space off the Post (M2) to be flush with the end of the currently attached panel(s) (M1).
Reference Distances are as follows:
Wall to center of First post:
95”
Center of Post to Center of Post:
96”
Secure the post to the floor using floor anchors (Not Supplied) Recommended: ½”DIA X
3.75”L Anchor
You may use holes in the posts (M1) as a drill guide. Refer to Figure (3-2) for
reference. Use Figure (3-1) for post orientation.
Fig.
3
‐
1
Inside
of
Room
Step
4:
Adding
a
Panel
(M1).
Place
the
panel
so
that
the
fl
anges
of
panel
are
facing
towards
the
inside
of
the
room.
(DO
NOT
ghten
as
that
is
the
last
step).
See
Figure
(3
‐
1)
for
reference.
The
lower
panel
should
be
approximately
(two)
2”
o
ff
the
ground
(for
Standard
Installa on).
If
you
have
a
ver cal
post
(M2)
with
a
2”X6”
base
you
may
use
that
post
as
a
spacer
by
laying
that
post
(M2)
on
its
side.
Insert
a
Panel
Clip
bracket
(B1)
around
the
end
wire
of
the
panel
(M1)
at
the
corresponding
predrilled
hole
of
the
post
(M2).
Refer
to
Figure
(5
‐
1)
for
reference.
Repeat
for
all
the
predrilled
holes
(3/Panel).
Fig.
3
‐
2
Step 5: Adding Top Panel (M1) Vertically.
Insert a Panel Clip bracket (B1) around the end wire of the panel (M1) at the corresponding predrilled
hole of the post (M2). Refer to Figure (5-1) for reference. Repeat for all the predrilled holes.
Approximately 2 Panel Clip brackets (B1) per 4’H Panel (M1)
Using the provided Carriage Bolt (F2), Hex Nut (F3), Washer (F4) secure the two panels together
equally spaced for (three) 3 locations of bolts. Refer to Figure (5-1) for reference.
Spaced equally through out the Panel (M1) span.
Some cutting may be required See (
Step 7
).
Fig.
5
‐
1