FS-PD2001-GM
Making methods of RJ45 connector
Required tools: wire crimpers, network cable tester.
1)
The wire sequence of RJ45l connector must complies with international standard of EIA/TIA 568A or EIA/TIA 568B.
2)
Strip about 2cm’s of insulating jacket to let 4 pairs UTP can be seen.
3)
Separate 4 pairs UTP cable, and try to straighten each pair.
4)
Arrange 8 cables with correct line sequence of EIA/TIA 568A or EIA/TIA 568B.
5)
Cut thread residue and leave 1.5cm wire which exposed outside the insulating layer, and ensure 8 wires are straight and neat.
6)
Put 8 wires in RJ 45 connector, then press with wire crimpers.
7)
Repeat above five steps , make the other side of UTP cable; Then using the cable tester to test whether the cat5e/6 works normally.
两种线序接线图
1
2
3
4
5
6
7
8
T568A White Green
Green
White
Orange
Blue
White Blue
Orange
White Brown
Brown
T568B White Orange
Orange
White Green
Blue
White Blue
Green
White Brown
Brown
Note: Ports of this device support Auto MDI/MDIX, so the different wire sequence at two sides of the cable is allowed when using RJ45 port for transmission
