Keypad Lock Retrofit Kit 3
4.
Position lock mechanism in jig cutout on door back.
Thread wire cable connector through jig
(Fig. 4)
.
Fig. 4
5.
Mark 4 holes onto door back through lock
(Fig. 5)
.
6.
Remove lock mechanism.
Fig. 5
7.
Reverse jig on door, aligning slot in jig with centerline
mark. Mark center hole on back on door
(Fig. 6)
.
8.
Center punch all marked holes.
9.
Drill all holes with .136 (#29) drill bit.
Warning: Do NOT drill completely through door.
Fig. 6
Summary of Contents for 00170688
Page 7: ...Keypad Lock Retrofit Kit 7...
