131
Continued on next page
T
one/Displa
y/Lighting Settings
Changing the pointer speed
1
Neuropointer screen (P.130) “Speed” Select any item:
*1 : Adjusts the pointer speed for typical screens such as list and icon selection.
*2 : The settings may be not applicable depending on the i-
α
ppli.
<Illumination>
i
i
8
8
9
9
Setting the Incoming Call Lamp Flashing Mode for Incoming Calls
Default setting
Phone: Color 5 Video-phone: Color 5 Mail: Color 1 Chat mail: Color 3
MessageR: Color 1
MessageF: Color 1
Set pattern: Standard
Color name: Color 1-12
Use this procedure to set the color and pattern (flashing pattern) in which the incoming call lamp flashes
when you receive voice or videophone calls, mail, chat mail and Message Request/Free.
●
You can set different flashing colors respectively for incoming calls and messages from specific phone
numbers, e-mail addresses and groups.
→
P.108
●
The flashing pattern for
o
and
p
is the same as for the incoming call lamp, but they flash orange.
1
i
“Incoming call” “Illumination” Select any item:
Item
Description
Pointer
Specifies whether to display the pointer (whether to use the neuropointer).
Speed
“Changing the pointer speed”
→
P.131
Slide
Adjust
“YES” Slide your finger over the neuropointer key
following the instructions
Sets the limits of the neuropointer key sliding to move the pointer as you like.
Reset
Restores the slide adjustment to the default settings.
Item
Description
Simple
“Normal” or “High” “YES”
Chooses between the two speeds.
Detail
Sets the speed for each screen.
Standard
*1
Use
c
to select “I”, “L” or “H” Use
v
to change
the speed
The speed can be adjusted from level 0 (left end) to level 11 (right
end). Move the key to the right to increase the speed and to the
left to decrease the speed.
MainMenu
T9/Prediction
Software
*2
Reset
Restores the pointer speed to the default settings.
Item
Description
Set color
Selects the flash color of the incoming call lamp for “Phone”, “Video-phone”, “Mail”, “Chat mail”,
“MessageR” and “MessageF”.
The incoming call lamp is turned on with the selected color during the selection.
Color 1 to 12: The lamp flashes by the selected color.
Gradation: The lamp flashes by the colors 1 to 12 in numeric order.
Set pattern
Selects the incoming call lamp flashing pattern.
Standard
Sets the standard flashing pattern.
Melody linkage
Sets a melody-linked flashing pattern.
Adjust color
Sets the color.
Edit color name
Select the color Enter the color name
The color name can contain up to 10 full-pitch or 20 half-pitch characters.
“Entering Text”
→
P.506
Adjust color tone
Select the color Use
b
to adjust the color tone
Summary of Contents for N901iS
