50
green lights are ON at the same time), and the status LED will display in green quick blinks then the
transmitter enters joystick correction mode.
7.3.3 Joystick Correction Steps
Proportional joystick:
1.
Select either joystick and operate it slowly. Then the buzzer will beep once briefly which means the
joystick axis direction catches the start position.
2.
Continue to operate the joystick swiftly to the end and hold. Then the buzzer will beep twice briefly
which means the joystick axis direction catches the end position. The directional axis correction is
now completed and joystick may back to neutral position.
3.
Repeat step 1 & 2 to correct the reverse directional axis of the joystick.
4.
Repeat step 1~3 to complete all joysticks correction. After the joystick correction is completed, the
buzzer will have a long beep once and then the joystick status LED blinks in orange slowly.
5.
When status LED display becomes orange blinking slowly, then setting is completed. Please refer to
8.3.4 for exiting
from correction mode.
Digital joystick 1~5 speeds:
1.
Select either joystick, operate it to the 1
st
speed position and hold. Then press START button and the
buzzer will beep once briefly. Release START button and the joystick axis direction catches the 1
st
speed position.
2.
Locate the 2
nd
~5
th
speeds directional axis by following step 1. Then operate the joystick back to the
neutral position after the correction is completed.
3.
Repeat step 1 & 2 to correct the reverse directional axis of the joystick.
4.
Repeat step 1~3 to complete all joysticks correction. After the joystick correction is completed, the
buzzer will have a long beep once and then the joystick status LED blinks in orange slowly.
5.
When status LED display becomes orange blinking slowly, then setting is completed. Please refer to
8.3.4 for exiting
from correction mode.
7.3.4 Exit
After all joystick correction is completed, rotate the transmitter power switch to OFF position and set
dip-switch S2 as 000000 as shown on below figure, then all joysticks exit the correction mode and back to
normal operation.
