- 26 -
6
6
.
.
T
T
R
R
A
A
N
N
S
S
M
M
I
I
T
T
T
T
E
E
R
R
S
S
E
E
T
T
T
T
I
I
N
N
G
G
S
S
6
6
.
.
1
1
H
H
o
o
w
w
t
t
o
o
S
S
e
e
t
t
I
I
D
D
C
C
o
o
d
d
e
e
s
s
6.1.1 Set by programming tool
6.1.2 Set by encoder board JP1, 1
st
/ 2
nd
pin and dip-switch
Setting Steps:
(1)
Rotate the transmitter power to OFF position
(2)
Remove the transmitter shock-absorbing rubber
(3)
Place the transmitter pushbutton side downward and unscrew the transmitter bottom casing.
(4)
Set the transmitter ID code with the dip-switch on the encoder board and put short boot on the 1
st
and
2
nd
pin of JP1.
(5)
Make sure the batteries are installed properly.
(6)
Rotate the transmitter power switch to ON position.
(7)
Green status LED ON for 0.1 sec, OFF for 0.1 sec, flash for 1 sec. (5 times)
(8)
Green status LED steady ON indicates the setting is completed. If the LED status light is changed to
red, the setting is failed. Please repeat the above setting steps until the setting is successful.
(9)
After setting is completed and successful, remove short boot from the 1
st
and 2
nd
pin of JP1.
(10) Rotate transmitter power switch to OFF position.
編碼板
(Fig. 11) Back view
(Fig. 12) Position of dip-switch & jumpers
Top slot ON
“1”; bottom slot
“0”. The setting above is 00000011.
