- 30 -
Short
* 4 pushbuttons: When either relay of pushbutton 1~4 is
activated, LV relay will also be activated.
* 8 pushbuttons: When either relay of pushbutton 1~6 is
activated, LV relay will also be activated.
* 12 pushbuttons: When either relay of pushbutton 1~8 is
activated, LV relay will also be activated.
JP3
(*2)
α608T only
Open
MAIN relay off, I & II relays remain unchanged
Short
MAIN relay off, I & II relay off
.
JP4
Open
7
th
AUX pushbutton: Set as “Normal”
Short
7
th
AUX pushbutton: Set as “Toggle”
“Start” means: MAIN relay unlatches and then latches.
※
Open
→
no Jumper Short
→
put Jumper
Remark 1
：
The setting of auto shutdown time can be done by manufacturer or distributor. Setting range: 0~30
minutes. (In-plant setting: 5 minutes)
Remark 2
：
When the transmitter voltage is low, LV relay will be activated and siren or lights will be ON. (One
second of interval)
Remark 3
：
Every time when you change jumper settings you must first turn the receiver power off and then turn
it back on so that the new settings can be stored in the memory.
7.3.2
α
612 Receiver Function Setting
7.3.2.1 Set by programming tool
Input from programming port CN3 and CN5. The data of CN3 and CN5 have to be identical.
7.3.2.2. Adjust Jumper setting function on decoder board
R
R
e
e
c
c
e
e
i
i
v
v
e
e
r
r
f
f
u
u
n
n
c
c
t
t
i
i
o
o
n
n
s
s
e
e
t
t
t
t
i
i
n
n
g
g
:
:
Jumper Set Table:
In-plant setting (default).
JP1
Open
Not available
Short
Transmitter power switch start (when MAIN is off)
JP2
Open
No function
Short
No function
JP3
Open
When the transmitter voltage is low, LV relay
activates/deactivates every second.
Short
When either relay of pushbutton 1~8 is activated, LV
relay will also be activated.
“Start” means: MAIN relay unlatches and then latches.
JP1/JP2 is for Mode 0, EN ISO 13849-1 version is for Mode 1 only:
JP1 setting is not available. Please proceed setting only when power is off.
JP2 No function
※
Open
→
No jumper Short
→
Put Jumper
