CONNECTION
- Make the connections with the amplifier and all the components of the installation switched off and
disconnected from the power supply.
- Connect the audio devices or required microphones to the corresponding inputs. A dynamic microphone
can be connected in the input designed for that purpose, located on the rear panel of the amplifier.
- Line level sources can be connected in the aux inputs designed for that purpose on the rear panel of the
amplifier.
- A USB storage device or an SD memory card can be connected. Select the required playback mode and
then you will be able to play music from external storage media. The amplifier also has an FM radio tuner
and bluetooth receiver.
- The amplifier is low impedance, therefore the loudspeakers must be connected in a series/parallel circuit
so that the load impedance of the loudspeakers is the same as the impedance of the amplifier output and
the power supplied by the amplifier does not exceed that withstood by the loudspeakers.
If using one of the loudspeaker output groups (A or B), the amplifier must be loaded with an equivalent
impedance of 4 to 16 Ω.
In the event of using both groups of loudspeaker outputs (A and B), the amplifier must be loaded with an
equivalent impedance of 8 to 16 Ω.
- Connect the amplifier mod to the power supply.
- Once the connections have been made according to your needs, connect the devices to the power supply
and switch them on. After use, do not forget to switch off and disconnect the device from the power
supply.
EN
- 7 -
AS-160WRUB_AS-161WRUB_MANUAL_(EN)_20170703_Maquetación 1 16/2/18 12:45 Página 7