CONNECTION
- Make the connections with the amplifier and all the components of the installation switched off and
disconnected from the power supply.
- Line level sources can be connected in the aux inputs designed for that purpose on the rear panel of the
amplifier (CD/PHONO and DVD) or in the AUX input on the front panel.
- If you wish, the optical audio inputs located on the rear panel of the amplifier can be used.
- A USB storage device or an SD memory card can be connected. Select the required playback mode and
then you will be able to play music from external storage media. The amplifier also has an FM radio tuner
and bluetooth receiver.
- The amplifeir is low impedance, therefore the loudspeakers must be connected so that the load impedance
of the loudspeakers is the same as the impedance of the amplifier output and the power supplied by the
amplifier does not exceed that withstood by the loudspeakers:
20 + 20 W RMS at 4 Ω
- Connect the amplifier mod.
AS-25RUB
to the power supply.
- Once the connections have been made according to your needs, connect the devices to the power supply
and switch them on. After use, do not forget to switch off and disconnect the device from the power
supply.
EN
- 7 -
AS-25RUB_MANUAL_(EN)_20161028_V9.1_Maquetación 1 1/2/17 11:02 Página 7
