INSTRUCTIONS FOR USE
ON AND OFF
Before switching the power amp on check that the volume controls for channels 1 and 2 are at their minimum.
Switch on the rest of the audio system and lastly, switch on the power amp and adjust the volume in the
channels.
To switch the audio system off, adjust the power amp volume to its minimum and switch it off. Lastly, switch
off the rest of the audio system.
PROTECTION
The power amplifier has 4 types of protection: overload, overcurrent, surge and temperature.
When protection is activated, an LED indicator will light up on the front panel and the audio output will be
cut off. If this happens, switch the power amp off, check what has caused the protection to be activated, leave
it to recover for a while and switch it on again.
RESETTABLE FUSE
The power supply source has been manufactured using advanced components that absorb current peaks
and eliminate fluctuations caused by turning the the amplifier on. Furthermore, it is equipped with a 10 A
BREAKER resettable fuse on the back panel.
If the fuse is cut off, due to a surge or excessive consumption, switch the power amp off, check what has
caused the fuse to be cut off, let it recover for a while and reset the BREAKER fuse by pressing it.
SPECIFICACIONES
FS-2503E
CHARACTERISTICS
2-channel power amp.
POWER
Stereo and parallel mode: 2 x 500 W RMS
Bridge mode: 1000 W RMS at 8 Ω
RESPONSE
30-20 000 Hz, ±3 dB
DISTORTION
Harmonic: < 1%
INPUT
2 balanced auxiliary lines, XLR, 700 mV
OUTPUTS
2 balanced auxiliary lines, XLR
FUNCTIONS
Forced ventilation
LED power, signal, clip, temperature and protection indicators
CONTROLS
Volume per channel, trimmer type
Operating mode selector PARALLEL/STEREO/BRIDGE
GND lift earth disconnection
PROTECTION
Overload, overcurrent, surge and temperature
S/N RATIO
> 90 dB
IMPEDANCE
4 and 8 Ω and 100 and 70 V lines, screw terminals
POWER SUPPLY
230/115 V AC, 1,800 W maximum
Resettable 10 A fuse
DIMENSIONS
483 x 89 x 410 mm depth. 2 U 19" rack
- 7 -
