To increase the power in a certain area, connect the line output from the chosen zone to the input on a
power amp., for example model FS-2601E. Use the 100 V high impedance line output on the power amp
to connect the speakers as shown in the following connection diagram.
Example of the connection of the line output from a zone to the FS-2601E power amp.
INSTRUCTIONS FOR USE
ON AND OFF
Before switching the amplifier on check that the output volume controls are at their minimum. Switch on the
rest of the audio system, and then lastly, the amplifier and adjust the output volume.
To switch the audio system off, adjust the output volume on the amplifier to its minimum and switch it off.
Lastly, switch off the rest of the audio system.
INPUT CHANNEL ALLOCATION TO OUTPUT ZONES
Each input channel CH1 to CH5 can be independently allocated to one or various output zones ZONE 1 to
ZONE 4.
Using the Z1, Z2, Z3, Z4 zone selector buttons for each channel located on the front panel, you can choose
the zone where the input channel signal is going to be sent.
For example if we want the CH1 channel to be heard in zones 1 and 2 and the CH2 channel in zones 1
and 3, in the CH1 channel zone selector we have to choose Z1 and Z2 and in the CH2 channel we must
choose Z1 and Z3.
- 7 -
EN
