FontanaShowers
©
FontanaShowers
©
FontanaShowers
FontanaShowers
Customer Service: 800-684-4489
fontanashowers.com
10
Commissioning Sequence
Before using the soap dispenser for the first time,
the following sequence must be carried out.
- Fill the bottle full of soap.
- Locate the dispense button on the side of the
pump. Press and hold the button until soap is
dispensed from the spout. This will ensure the
dispenser tube and cable are full of soap.
Operation
Place your hand under the spout within the sensing
range.
Once the your hand is detected, a small amount of
soap will be dispensed from the spout into your'
hand.
General Information
Our sensor spouts have a non-touch control which
uses infrared sensing technology to detect human
presence. Once detected, the spout instantly
dispenses water and automatically stops once the
user moves their hands away to eliminate
unnecessary water wastage, whilst creating a more
hygienic washroom solution.
All products manufactured and supplied by Fontana
are safe and comply to legislative requirements.
Providing they are installed correctly and receive
regular maintenance in accordance with these
instructions your user experience will not be
affected.
Incorrect Placement
Keep sensor range adjustment
within 4 inches away from center
of spout. This can only be done
with optional remote control.
Installing electronic soap dispenser
& faucet with intersecting centerline
might lead to accidental activation
of either or both.
Faucet
Faucet
Soap
Dispenser
Soap
Dispenser
Correct Placement
Keep sensor ranges
factory preset.
Keep soap spout & faucet
centerlin parallel.
Faucet
Faucet
Soap
Dispenser
Soap
Dispenser
Sensor Faucet & Soap Dispneser Installation
Care & Cleaning
• Always wipe your fixture down with a soft cloth
after each use to prevent mineral build-up and
water-spotting. Should spotting occur, remove
water spots with warm water and a soft, damp cloth.
• Wipe away any debris adhering to the spout or
sensor.
• Wipe away debris with a damp cloth containing a
suitable amount of a neutral, dishwashing
detergent. Then wipe clean with a damp cloth.
• When cleaning around the sensor, please be
careful not to scratch the surface of the sensor
window.
• Do not use detergent that might damage the
surface of spout. These include:
- Detergents containing acid, chlorine bleach or
alkali.
- Detergents that are coarse granules in nature,
such as polishing powder.
- Solvents such as paint thinner or benzene.
- Abrasive aids such as nylon scrubbers/brushes,
steel wool, etc.
Hygienic
The proximity sensor faucet removes the need to
touch the faucet body, reducing the spread of
germs and the chance of cross-contamination.
