20
• ENGLISH •
• ENGLISH •
Press the buttons “A” on the inner side of the frame and fold down the handlebar and the canopy as
shown in the figure (fig. 21).
Press the handlebar against the backrest to activate the locking device and, at the same time, lift up the
bumperbar to close the stroller (fig. 22).
Lock the stroller in the position with the locking device located on the side. This operation prevents the
accidental opening of the stroller
(fig. 23).
To reduce the dimensions:
• Remove the bumperbar.
• Remove the rear wheels.
Insert the stroller into the carrying bag (fig. 24).
OPTIONAL
USING THE TRAVEL SYSTEM ACCESSORY ONBOARD Type FB-806 INFANT CAR SEAT (OPTIONAL)
The BOARDING pushchair can be used with ONBOARD infant car seat.
Remove the stroller reducer
Raise the backrest to the vertical position.
Remove the bumper bar from the chassis (see the paragraph “FITTING THE BUMPER BAR”).
FITTING THE RIGHT AND LEFT ADAPTER
(fig.27):
Line up and insert the right and left adapter in the slots provided on the chassis of the pushchair.
Press until a click is heard indicating that the adapter has been secured correctly.
WARNING
: Before use, always make sure that both the adapters have been secured correctly to the
chassis. When lifted they must not detach from the chassis.
REMOVING THE ADAPTERS
(fig.28): press button “A” to remove the adapter.
USING THE INFANT CAR SEAT TRAVEL SYSTEM ACCESSORIES
IMPORTANT
: the travel system accessory must be secured to the chassis only in the parentfacing
position (fig.29).
Fitting the accessory:
Line up the locking mechanism fitted on the accessory with the
adapters and press downwards until a click is heard indicating that the accessory has been fastened
correctly to the pushchair chassis complete with adapters (fig. 30). Make sure that the accessory has been
fastened correctly on both sides.
WARNING
: Before use, always make sure that the accessory has been secured correctly. When the
accessory is lifted upwards it must not detach from the pushchair chassis.
Removing the accessory:
Pull levers “A” on both sides and remove the accessory by lifting it using the handle (fig. 31, 32).
ASSEMBLY / USE
Summary of Contents for BOARDING
