• ENGLISH •
• ENGLISH •
24
USING THE CAR SEAT
2.3 USING THE BUCKLE
After adjusting the height of the straps, as shown in section 2.6, proceed as
follows:
Step1.
Join the two metal parts of the buckle connectors together.
Step 2.
Insert the two buckle connectors into the buckle slot until you hear a
“click”.
Step 3.
Check that the harness is correctly fastened by pulling on the straps
upwards. To unclip the harness, press the red button on the buckle.
2.4 ADJUSTING AND USING THE HARNESS
Loosening the harness
To loosen the harness, press the adjustment
device lever (under the lining) located on the front
part of the car seat.
With one hand, hold the adjustment devise lever
down and, with the other hand, pull on the straps
(chest belts) by gripping them on the lower part,
below the chest protector padding, to loosen
them.
IMPORTANT:
Do not pull on the straps by
gripping the chest protector padding.
3
2
1
1
2
3
CLICK
CLICK
PRESS
PRESS
forwar dfacing
rear facing
3
2
1
1
2
3
CLICK
CLICK
PRESS
PRESS
forwar dfacing
rear facing
Summary of Contents for MYDRIVE
