87
7-18. ANALOG AUDIO OUTPUT MAPPING
- - - A N A L O G A U D I O O U T P U T M A P P I N G - - - P 6 3 3
C H A s s i g n S o u r c e C H A s s i g n S o u r c e
F 1 1 : F S 1 I n - C H 1 F 3 2 : F S 1 I n - C H 2
3 : F S 1 I n - C H 1 4 : F S 1 I n - C H 2
Parameter
Default
Setting range
Description
CH1 - CH4
FS*-CH1-4
FS1 In Ch1-16
|
FS5 In Ch1-16
Silence
500Hz Tone
1KHz Tone
Down Mix1-L
Down Mix1-R
|
Down Mix5-L
Down Mix5-R
AES(A) In-CH1
|
AES(A) In-CH8
AES(B) In-CH1
|
AES(B) In-CH8
AES(C) In-CH1
|
AES(C) In-CH8
AES(D) In-CH1
|
AES(D) In-CH8
Analog In-CH1
|
Analog In-CH4
Allows you to select an audio channel to
output to the FA-10ANA-AUD analog
audio output.
* Displays the FS number (FS1 to FS5) of the selected FS.
Control knobs F1 and F3 allow you to navigate audio channels one by one. Control knobs F2
and F4 allow you to navigate audio channels in block units.
Move the F1/F3 indication to the item to be changed using the single-arrow buttons.
To change the FS selection to set settings, refer to section 5-3-7.
AES(A) In-CH1 - AES(D) In-CH8 are displayed if an FA-10AES-BL/ FA-10AES-UBL is
installed in slot A-D.
Analog In-CH1 - Analog In-CH4 are displayed if an FA10ANA-AUD is installed.
BY-PASS
MAPPING
4
