47
White Knee Point
(Variable)
50.0 (Min.)
(0.5%)
Allows you to set the upper knee point.
Default and maximum values change
according to the White Level (RGB White
Clip) setting.
White Knee Slope
Off
Off, 1 - 15
Allows you to set the upper knee slope.
Black Level
(RGB Black Clip)
-50.0%
-50.0 - 50.0%
(0.5%)
Allows you to set the RGB lower clip level.
Black Knee Point
(Variable)
50.0% (Max.)
(0.5%)
Allows you to set the lower knee point.
Default and minimum values change
according to the Black Level (RGB Black
Clip) setting.
Black Knee Slope
Off
Off, 1 - 15
Allows you to set the lower knee slope.
* If loading events that were saved in Software Version 1.21 or earlier to an FA-505 with software version
2.00 or later, White Level and Black Level settings will be reset.
6-14-6. If Mode is RGB Clip (FA-505 V1.21 or earlier)
F S 1 N a m e : F S 1
- - - V I D E O C L I P - - -
P 5 1 1
F 1 M o d e : R G B V i d e o C l i p
F 2 W h i t e L e v e l : 3 0 0 . 0 %
F 3 B l a c k L e v e l : - 2 0 0 . 0 %
Parameter
Default
Setting range
(Steps)
Description
White Level
(RGB White Clip)
300.0%
50.0 - 300.0%
(0.5%)
Allows you to set the upper threshold
of RGB color space.
Black Level
(RGB Black Clip)
-200.0%
-200.0 - 50.0%
(0.5%)
Allows you to set the lower threshold
of RGB color space.
To change the FS selection to set settings, refer to section 5-3-7.
To simultaneously change settings of multiple FSs, refer to section 5-3-8.
* If the selected FS bypasses the Color Correction process, this menu is disabled. Change
COLOR
CORRECTION BY-PASS
to
Operate
, then reset the parameter. (See section 6-16.)
6-15. SDI VIDEO BY-PASS
- - - S D I V I D E O B Y - P A S S - - -
P 5 1 5
F 1 S D I 1 a - I / O : O f f
S D I 2 a - I / O : O f f
S D I 3 a - I / O : O f f
S D I 4 a - I / O : O f f
S D I 5 a - I / O : O f f
A L L S D I I / O : O F F
Parameter
Default
Setting range
Description
SDI1a - 5a-I/O
Off
Off
On
Allows you to set BY-PASS for each SDI
channel. Displays
“---“ if BY-PASS cannot
be set.
ALL SDI I/O
Off
Off
On
On:
Sets all SDI input channels to bypass
signals.
Move the F1/F2 indication to the item to be changed using the single-arrow buttons.
BY-PASS
MAPPING
4
CLIP
DWN MIX
3
