19
4. MFR Operation
4-1. Functions and Operations
Remote control unit functions and Web-based control functions that can be operated from the
MFR-RULINK-side LAN are shown in the table below.
* R
efer to “Operating manual of MFR series Web based control” for detailed setting procedures.
Operation
: Setting changes and command execution are both supported.
: Command execution is supported.
▲: Setting changes are supported.
39: Settable by MFR-39RU/39RUA.
18: Settable by MFR-18RU/18RUA
16D: Settable by MFR-16RUD
16T: Settable by MFR-16RUTA
Controller
Functions
Remote control unit
Web-based Control
Main
Unit
MFR-
RULINK
Main
Unit
MFR-
RULINK
Crosspoint
change
(1 channel)
Source and/or destination
changes
○
○
○
---
Use of bus buttons
○
○
---
---
Use of buttons and CONTROL
knob
18, 16T
18, 16T
---
---
Display use
16D
16D
---
---
CHOP function
●
●
---
---
TAKE function
●
●
○
---
Crosspoint
changes
(Simultaneous)
Main unit stored SALVO
●
---
▲
---
Control panel button assigned
SALVO
39 ●
39 ●
▲
▲
TAKE function
●
●
○
---
LINK function
●
---
▲
---
Erroneous
operation
protection
LOCK LOCAL
○
○
---
---
LOCK OTHER/ LOCK ALL
○
○
○
---
Crosspoint inhibit
---
---
○
○(*4)
Monitor output function
(*1)
●
---
---
---
Operation Preview function
●
●
---
---
Main unit and
system setting
change
Source/destination name settings
---
---
○
○
System tally settings
---
---
○
---
Remote
control unit
setting
changes
Mode menu
39, 18, 16T
39, 18, 16T
---
---
Button assignment
39, 18, 16T
(*2), 16D
39, 18, 16T
(*2), 16D
○(*5)
○(*5)
PAGE function
○
○
---
---
Multi-remote control unit panel
operation
39 (*3)
39 (*3)
▲(*5)
▲(*5)
IP address setting
39
39
▲(*5)
▲(*5)
Other settings
39
39
○(*5)
○(*5)
Status display
●
●
●
●
Alarm display
●
●
●
●
*1 This function is supported only for the MFR-5000/8000.
*2 Source and destination button/channel assignments can be performed using
CONTROL
on
MFR-18RU / 16RUTA / 18RUA / 39RUA units.
*3 MFR-39RU / 39RUA able to change multi-remote control unit panel operation settings while
other remote control unit panels can only be used for operation.
*4 When main unit and MFR-RULINK settings are different, inhibit procedures set by the main
unit are not reflected on the remote control unit display, but Crosspoint change are inhibited.
*5 Remote control unit setting changes are possible in the respective LAN of the main unit and
the MFR-RULINK LANs.
