10
3. Connection
3-1. Installing to a UFM frame
UFM-30MUX and UFM-3MUXAI modules are used by installing them into UF-106B or UF-112
UFM frames.
UFM-30MUX
UFM-30MUX modules can be installed in any empty slot on UFM frames.
A UFM-30MUX module set consists of a front and rear module. Be sure to always install the
front and rear modules in the same slot positions.
UFM-3MUXAI
Install a UFM-3MUXAI module set into the slot
just below the UFM-30MUX slot
.
(1) Attach the gasket supplied with the UFM-3MUXAI on the UFM-30MUX card as shown in the
figure below.
Then, connect the UFM-30MUX and UFM-3MUXAI front modules with the supplied flat cable.
Bend the flat cable as shown in the figure below.
IMPORTANT
Make sure that when a UFM-3MUXAI is connected to the UFM-30MUX, the supplied
gasket is attached to the UFM-30MUX card.
(2) After connecting the flat cable, align the two module cards so that the pivot post on the
UFM-3MUXAI card is correctly inserted into the pivot hole of the UFM-30MUX card.
Insert the pivot post
into the long hole.
Attach the gasket.
Connect the two front
modules by bending the
flat cable
Back face of UFM-30MUX
front module
Front face of UFM-30MUXAI
front module
USO
RESTRITO