12
3-2. Basic Configuration (UFM-30MUX)
Connect UFM-30MUX modules to peripheral devices referring to the figure below.
SDI signal
DIGITAL AUDIO IN
UFM-30MUX
INPUT
OUTPUT
1/2
3/4
5/6
7/8-LTC
3G/HD/SD-SDI 3G/HD/SD-SDI
DIGITAL AUDIO IN
UFM-30MUX
Audio embedded SDI signal
3-3. Optional Configuration (UFM-3MUXAI)
UFM-30MUXAI
LTC IN
ANALOG AUDIO IN
UFM-3MUXAI
ANALOG AUDIO IN
LTC IN
IMPORTANT
The UFM-30MUX and UFM-3MUXAI front modules must be connected using the
supplied flat cable.
3-3-1. Analog Audio Connection
For balanced audio signals, connect the
hot
,
cold
and
shield
conductor to "+
"
,"
-
" and
"
COM"
pins respectively.
For unbalanced audio signals, connect the conductor that carries
audio
to a "
+
" pin and
ground
to "
COM.
"
Use jumpers on the front module to switch between balanced and unbalanced
stereo audio. See section 8-1. "UFM-3MUXAI FRONT CARD" for details.
INPUT
OUTPUT
1/2
3/4
5/6
7/8-LTC
3G/HD/SD-SDI 3G/HD/SD-SDI
DIGITAL AUDIO IN
UFM-30MUX
USO
RESTRITO
